How to Use Attack Move

[WarmasterSteve]

Hey y'all.

Sometimes when I use attack move my engineer will just move to the location without reclaiming, no matter how much I keep redoing the command it never reclaims. Is there something special about where you place the command etc?

Also, when reclaiming groves of trees, my reclaim command will snap from where I placed it to the nearest reclaim point. This is fine, but sometimes my attack move command will do the same thing.

Other times, it works perfectly fine.

Any ideas on how to use this command effectively?

[speed2]

Try to not have full storages and engineers will reclaim

[JoonasTo]

Commands will snap to something when there's something there to snap to. Units, buildings, wrecks, treegroups, rocks, etc.
So place them a bit farther from the objects and they won't snap.

[WarmasterSteve]

Thank you!

I tried reclaiming with half full storage and it worked! The command snapping only was an issue when my storage was full.